SoundID Reference for multichannel with Measurement Microphone

System Requirements
● Mac: macOS 10.12 or later
● PC: Windows 8 (64-bit) or later 1
● Sonarworks supported or Sonarworks individually calibrated headphones required (not included)
● 2.0 or 2.1 stereo speaker system
● An audio interface featuring +48V Phantom Power and 44.1 kHz sample rate capability
● During the speaker measurement process, the audio hardware setup must consist only of a single external hardware device
● XLR to XLR audio cable
● SoundID Reference measurement microphone, or other omnidirectional measurement microphone with an XLR audio connection

Microphone Specification
● Houses a pre-polarized electret-condenser capsule
● Frequency response: 20 Hz - 20 kHz with a supplied calibration profile
● Omnidirectional polar pattern
● Sensitivity is rated at -37 dB/Pa (14 mV)
● Self noise: 24 dB
● S/N ratio: 70 dB
● Dynamic range: 106 dB
● Maximum SPL: 132 dB

SoundID Reference software for multichannel.Includes the SoundID Reference app for Windows and Mac, Measure module for speaker measurement, as well as the DAW plug-in (AU, VST, AAX). Includes individually calibrated Sonarworks measurement microphone. Bundle packed in a retail box; valid for 3 installs.

Sonarworks SoundID Reference for Multichannel

Intuitive speaker calibration software anyone can use to measure and calibrate a multichannel setup

Get this intelligent software that calibrates speaker setups up to 9.1.6 Dolby Atmos to ensure consistent, accurate monitoring in an endless array of production environments. It also offers ready-to-use calibration for more than 400 models of headphones. 

SoundID Reference for Multichannel works by applying a calibration profile to your monitoring output, supplying you with a ruler-flat response across all audible frequencies.