SoundID Reference - Upgrade from Headphones to Speakers & Headphones SW5UHSD

System Requirements
● Mac: macOS 10.12 or later
● PC: Windows 8 (64-bit) or later 1
● Sonarworks supported or Sonarworks individually calibrated headphones required (not included)
● 2.0 or 2.1 stereo speaker system
● An audio interface featuring +48V Phantom Power and 44.1 kHz sample rate capability
● During the speaker measurement process, the audio hardware setup must consist only of a single external hardware device
● XLR to XLR audio cable
● SoundID Reference measurement microphone, or other omnidirectional measurement microphone with an XLR audio connection

Microphone Specification
● Houses a pre-polarized electret-condenser capsule
● Frequency response: 20 Hz - 20 kHz with a supplied calibration profile
● Omnidirectional polar pattern
● Sensitivity is rated at -37 dB/Pa (14 mV)
● Self noise: 24 dB
● S/N ratio: 70 dB
● Dynamic range: 106 dB
● Maximum SPL: 132 dB

Key to upgrade your copy of SoundID Reference for Headphones to SoundID Reference for Speakers & Headphones. Digital upgrade key delivered electronically. Will require Sonarworks measurement microphone purchased separately

Product description

Unify all of your monitoring devices under the same reference sound and switch seamlessly between your speakers and headphones. With this upgrade, you will add speaker calibration in addition to an already existing set of features offered by SoundID Reference for Headphones. As a result, you will hear every detail across the frequency response spectrum and will trust every mixing decision you make.

Key features

• Reliable, consistent, easy-to-use calibration software for all of your audio system:
• Ready-to-use headphone calibration for 480+ models
• Accurate speaker measurements and calibration for stereo systems
• 3 filter modes: Zero Latency, Mixed and Linear Phase
• Additional DSP processing controls: Mono, Dry/Wet, and Safe Headroom  
• MIDI mapping in the SoundID Reference app for various controls
• User Presets in the SoundID Reference app for switching quickly between predefined output device/channel pair combinations

• Reviews (0)

     0 reviews

  Write a review